The ideal solution for buildings with low overhead headroom or strict roof restrictions. All load rests directly on the pit foundation — eliminating roof superstructure and structural wall stresses.
Not every building can accommodate an overhead traction machine room or deep roof clearance.
Samrudhya Hydraulic Elevators are engineered to solve tough architectural constraints. Driven by submerged Italian hydraulic power packs and precision-honed piston rams, these systems deliver exceptional lifting torque for low-rise private residences, commercial showrooms, and heritage buildings up to G+4 floors.
Because the hydraulic cylinder and oil reservoir can be positioned remotely up to 10 meters away from the hoistway (even under a staircase or in a basement corner), architects enjoy complete freedom with clean, uncompromised roof terraces and skylights.
Italian precision valves, vibration isolation & smooth proportional flow
Engineered to overcome structural boundaries while ensuring whisper-smooth motion and foolproof mechanical rescue.
The motor and screw pump operate completely submerged in hydraulic fluid inside an acoustically insulated tank, eliminating pump whine and mechanical clatter.
All vertical payload and car deadweight are transferred straight down into the solid concrete ground slab, making hydraulics ideal for heritage retrofits and glass frameworks.
Descent is controlled purely by gravitational fluid release through modulated proportional valves. The electric motor does not run during descent, saving 50% power on return trips.
Even in a catastrophic blackout where battery systems fail, turning a simple manual brass bypass valve at the pump tank immediately lowers the car safely to the ground floor.
Standard configurations compliant with Indian Standards (IS 14665 Hydraulic Lift Codes).
| Specification Parameter | Residential Hydraulic Configuration (300–450 kg) | Engineering Notes |
|---|---|---|
| Rated Passenger Capacity | 300 kg – 450 kg (4 to 6 Persons) | Optimal for residential villas, duplexes & low-rise offices |
| Operating Travel Speed | 0.3 m/s – 0.5 m/s | Proportional valve acceleration with zero jerk |
| Max Travel Height | G+1 to G+4 Floors (Up to 14 meters travel) | Single or two-stage telescopic cylinder system |
| Shaft Minimum Size | 1300 mm (W) × 1350 mm (D) | Direct-acting side ram or 1:2 roped cantilever arrangement |
| Pit Depth | 250 mm – 450 mm (Shallow pit) | Minimal excavation required at lowest floor level |
| Headroom Clearance | 2700 mm – 3000 mm (Ultra low headroom) | Can fit directly underneath standard domestic ceiling heights |
| Machine Room Location | Remote Cabinet (up to 10m away) or Pit-Mounted | Can sit in basement, garage, or under stairs cabinet |
| Power Supply Specification | Single Phase 220V or Three Phase 415V, 50Hz | Zero motor power drawn during downward travel |
Certified mechanical pipe rupture safety valves and electronic pressure safeguards prevent anomalous descent.
Mounted directly at the cylinder base, this mechanical valve automatically locks fluid escape instantly if fluid flow rate exceeds calibrated velocity.
Utility outages automatically trigger a 12V battery solenoid valve that opens gravitational return, gently lowering the car to the bottom landing.
Thermostatic monitoring shuts down motor operation if fluid temperature exceeds 65°C, resuming automatically once oil cools to normal range.
Guards against excessive system pressure if car is overloaded, safely returning excess pump fluid back into the reservoir tank.
Allows service engineers to pump the cabin manually upward or lower it downward during specialized maintenance audits.
Full-height infrared light mesh continuously guards the entrance, instantly reopening automatic sliding doors when an obstruction is detected.
Key facts on machine room placement, power consumption, travel heights, and fluid maintenance.
Explore our heavy Goods Elevators and private Home Elevators, professional Installation Services, specialized Hydraulic AMC Maintenance, and genuine Hydraulic Valve Spares.
Speak directly with an elevator specialist. We provide complimentary site surveys, head-height feasibility audits, and customized hydraulic engineering proposals.
+91 98861 98146
+91 88844 21146
Uttarahalli Main Road, Bangalore, Karnataka
